Homeowner guide
How to Find Your Main Water Shutoff Valve and Turn It Off
Short answer
The main water shutoff valve is usually where the water line enters the house: on the basement front wall, in a crawl space, in the garage, near the water heater or, in warm climates, outside on an exterior wall. Most homes also have a curb stop at the meter.
Turning off the main stops every faucet, toilet and appliance at once. In a burst pipe or major leak, the minutes it takes to find the valve can decide how much damage your home takes.
Why should every homeowner know where the main shutoff is?
When a supply pipe bursts, a water heater fails or a washing machine hose splits, water keeps flowing until someone stops it. Plumbers and insurance adjusters see the same pattern again and again: the damage was made worse because no one in the house knew where the valve was or could not turn it.
Take ten minutes now to find the valve, make sure it works, label it and show everyone in the household. If the valve is stuck, broken or missing, a plumber can install a new one. See main shut-off replacement.
Where is the main water shutoff valve in my house?
The valve is almost always close to where the water service line enters the building, usually on the side of the house facing the street or the water meter. Common locations by home type:
| Home type or climate | Where to look first |
|---|---|
| Home with a basement (common in colder climates) | On the foundation wall facing the street, often near the water meter if the meter is indoors, low on the wall or near the floor |
| Crawl space home | Just inside the crawl space access near where the line comes through the foundation, or sometimes in a utility closet above it |
| Slab-on-grade home | In the garage, a utility room, near the water heater, or in an interior closet on an outside wall |
| Warm climates (South, Southwest, Florida, California) | Outside, on an exterior wall near a hose bib, often on the front or side of the house; sometimes in a small in-ground box near the foundation |
| Condo or apartment | Under the kitchen or bathroom sink, behind an access panel, near the water heater or in a utility closet; some units share a valve controlled by building staff |
| Manufactured home | Under the home near where the line enters, or behind an access panel in a bathroom or utility area |
Other clues: follow the pipe from the water meter, look for the thickest pipe coming through the floor or wall, and check your home inspection report, which often notes the valve location.
What is the curb stop and when should I use it?
Most homes on city water have a second shutoff, called the curb stop or curb valve, at or near the water meter. It is often in a covered box in the front yard, near the sidewalk or at the property line. In some areas the meter and curb stop are in a pit with a heavy lid.
Use the curb stop when the house valve fails or the leak is on the line between the meter and the house. Keep in mind:
- It often needs a special tool called a meter key or curb key.
- Some water utilities prefer that only their staff operate it, and some treat the meter side as their property. Check with your utility.
- Meter boxes can hold spiders, insects and standing water. Use gloves and a flashlight.
If you have a private well, there is no curb stop. Shut off the well pump at its breaker and close the valve after the pressure tank.
How do I turn off the main water valve?
There are two common types of main shutoff valves:
- Ball valve (lever handle): turn the lever a quarter turn so it sits across the pipe. When the lever lines up with the pipe, it is open. Ball valves are newer, quick and reliable.
- Gate or globe valve (round wheel handle): turn the wheel clockwise until it stops. It may take several full turns. Do not force it with a wrench if it will not move, since old valves can break.
After closing the valve, open a faucet on the lowest floor to confirm the water stops and to drain pressure. If water keeps flowing, the valve is not sealing.
When turning water back on, open the valve slowly, then run faucets to let out air. Opening it all at once can cause water hammer and stir up sediment.
How do I test the main shutoff valve once a year?
Valves that sit untouched for years can seize or stop sealing. A quick yearly test:
- Pick a time when no one needs water.
- Close the valve fully.
- Open a faucet and make sure the flow stops within a short time.
- Reopen the valve slowly.
- Check the valve stem and packing nut for drips after reopening. A small drip from the stem can often be stopped by snugging the packing nut slightly.
If the valve will not turn, will not shut off the water or leaks after use, have a plumber replace it, ideally with a full-port ball valve. That is usually a short job and a good investment before an emergency happens.
What other shutoff valves should I know about?
- Fixture stops: small valves under sinks and behind toilets turn off one fixture.
- Water heater cold supply valve: on the cold inlet pipe at the top of the tank.
- Washing machine valves: behind the washer, one for hot and one for cold. See laundry room connections.
- Irrigation shutoff: often near the backflow preventer outside. See backflow testing.
- Outdoor faucet shutoffs: in cold climates, inside valves that let you drain hose bibs before winter.
- Gas shutoff: different from water. If you smell gas, do not search for valves. Leave the home and call your gas utility or 911 from outside.
Tips to make the valve easy to use in an emergency
- Tag the valve with a bright label that says MAIN WATER SHUTOFF.
- Keep the area clear. Do not let storage boxes or shelves block it.
- Keep a meter key and a flashlight near the door if you might need the curb stop.
- Take a photo of the valve location and save it on your phone, and share it with family and anyone house-sitting.
- If the valve is in a hard spot, like deep in a crawl space, ask a plumber about adding an accessible valve.
- Consider an automatic leak detection shutoff valve that closes the main when sensors detect water.
When should I call a plumber?
Frequently asked questions
Which way do I turn the water shutoff valve?
For a round wheel handle, turn clockwise to close. For a lever ball valve, turn it a quarter turn so the handle is across the pipe.
Is the main water shutoff inside or outside?
It depends on climate and home design. In cold climates it is usually inside, often in a basement. In warm climates it is often outside on an exterior wall. Most homes also have a curb stop at the meter.
What if my main shutoff valve is stuck?
Do not force it with a long wrench, since old valves can snap. Use the curb stop if needed and have a plumber replace the valve.
Can I turn off the water at the meter myself?
Often yes, with a meter key, but some utilities ask customers not to operate their valves. Check your utility's rules, and in an emergency, call them if you cannot shut off water at the house.
Should I turn off the main water when I go on vacation?
Many insurers and plumbers recommend it, especially for longer trips and in winter. If you have a gas water heater, set it to vacation mode or follow the maker's instructions.
Related services
Need a plumber?
Drains, leaks, water heaters, sewer lines and emergencies, day or night.
Call (855) 902-0055