Plumbing services
Toilet, Sink, Faucet & Shower Repair
Fixture repair covers the everyday plumbing problems in kitchens and bathrooms: running or leaking toilets, dripping faucets, leaking sink drains and supply lines, and showers with low flow or no hot water. Most are fixed by replacing a worn part such as a flapper, fill valve, faucet cartridge, washer, O-ring or shower valve cartridge, often in a single visit.
Small fixture leaks add up. A running toilet or dripping faucet wastes water every hour, and a slow leak under a sink can rot the cabinet floor before anyone notices.
Signs you need toilet, sink, faucet & shower repair
- A toilet that runs, refills on its own or hisses
- Water on the floor around the toilet base
- A wobbly toilet
- A faucet that drips or leaks at the handle
- Water under the sink or a damp cabinet floor
- Low pressure or flow at one faucet or showerhead
- Shower that will not get hot or changes temperature suddenly
- Shower or tub spout that drips after it is turned off
- Loose or stiff handles
Common Toilet Repairs
| Problem | Likely cause | Typical fix |
|---|---|---|
| Runs constantly or refills on its own | Worn flapper, chain too short, water level set too high | Replace flapper, adjust chain or float |
| Slow to fill or noisy fill | Worn or clogged fill valve | Clean or replace fill valve |
| Weak flush | Low water level, clogged rim jets, partial clog | Adjust level, clean jets, clear drain |
| Leak at base | Failed wax ring, loose bolts, cracked flange | Pull toilet, replace wax ring or flange |
| Leak between tank and bowl | Worn tank-to-bowl gasket or bolts | Replace gasket and bolts |
| Wobbles | Loose bolts or damaged flange | Tighten, shim or repair flange |
A simple dye test can confirm a leaking flapper: put a few drops of food coloring in the tank, wait without flushing, and see whether color appears in the bowl. For more, see our toilet repair page.
Faucet Repair: Cartridges, Washers and O-Rings
How a faucet is repaired depends on its type:
- Compression faucets (separate hot and cold handles that tighten down) use rubber washers that wear out. Replacing the washer and seat usually stops the drip.
- Cartridge faucets use a replaceable cartridge. A drip or stiff handle usually means a worn cartridge.
- Ball faucets (single handle on a rounded cap) use a ball, seats and springs that can be replaced as a kit.
- Ceramic disc faucets are very durable, but seals can wear or debris can damage the discs.
Leaks at the base of a faucet spout often come from worn O-rings. Leaks under the sink are often a loose or failed supply line, a worn shut-off valve, or a loose drain connection or P-trap.
The plumber identifies the brand and model so the correct replacement part is used. Many manufacturers sell exact-fit cartridges, which keeps the original faucet working.
Sink and Drain Leaks
Water under a sink usually comes from one of four places: the supply lines, the shut-off valves, the faucet body, or the drain (basket strainer, tailpiece, P-trap or disposal connection). A plumber dries everything, runs water and watches each connection. Old braided supply lines and stuck shut-off valves are worth replacing during the same visit. For clogs rather than leaks, see drain cleaning.
Shower Valve and Showerhead Repair
Most shower problems come from the valve behind the handle:
- Drips from the showerhead or tub spout usually mean a worn cartridge or valve seals.
- Sudden temperature swings point to a pressure-balancing or thermostatic cartridge that is worn or clogged.
- Not enough hot water can be a cartridge with a misadjusted limit stop, a valve problem, or the water heater itself.
- Low flow at one shower is often a showerhead clogged with mineral scale or a flow restrictor. Hard water makes it worse.
- Diverter problems (water from the tub spout while the shower is on) are fixed by replacing the spout diverter or valve part.
Cartridges can often be replaced from the front after removing the handle and trim. Replacing the valve body itself usually requires opening the wall from behind or around the valve, and may involve tile work.
Repair or Replace the Fixture?
Repair is usually best when parts are available and the fixture is in good condition. Replacement makes sense when:
- The faucet or valve is corroded, cracked or leaking from the body.
- Parts are no longer available for an older model.
- A toilet bowl or tank is cracked.
- An old toilet uses far more water per flush than current models. Federal standards limit new toilets to 1.6 gallons per flush, and WaterSense-labeled models use 1.28 or less.
- You want features such as a pressure-balancing shower valve, which helps prevent scalding and is required by many codes in new installations.
What a Fixture Repair Visit Looks Like
- The plumber asks about the symptom and checks the fixture.
- Water to the fixture is shut off at its stop valve or at the main.
- The fixture is taken apart and the worn part is identified.
- The part is replaced, or the plumber explains why replacement of the whole fixture is the better choice.
- Water is restored and the repair is checked for leaks and proper operation.
Many fixture repairs take under an hour once the right parts are on hand.
What Affects the Cost of Fixture Repair
- Type of repair and part needed
- Fixture brand and part availability
- Access, such as a shower valve behind tile
- Whether the fixture is repaired or replaced, and who supplies the new fixture
- Number of fixtures handled in one visit
- After-hours or emergency service
Grouping several small repairs into one visit is often more efficient. Fixture repair is part of our fixture services. Call (855) 902-0055 to reach a local plumber.
How it works
- Call (855) 902-0055Tell us what is going on and your address. We answer 24/7.
- A local plumber comes outA plumber serving your area arrives, finds the problem and explains it.
- Fixed rightYou get the price before work starts, then the job is done and cleaned up.
Toilet, Sink, Faucet & Shower Repair: common questions
Why does my toilet keep running?
Most often the flapper is worn and not sealing, the chain is tangled or too short, or the fill valve is set too high and water spills into the overflow tube. Replacing the flapper or adjusting the fill valve usually fixes it.
How do I stop a dripping faucet?
The fix depends on the faucet type. Compression faucets need new washers. Cartridge, ball and ceramic disc faucets need a new cartridge, seals or kit. Shut off the water under the sink first if you try it yourself.
Why does my shower suddenly get hot or cold?
The pressure-balancing or thermostatic cartridge in the shower valve may be worn or clogged with mineral deposits. Replacing the cartridge usually restores steady temperature.
Is a leaking toilet base an emergency?
It is not usually a flood, but water at the base can soak the subfloor and the ceiling below. Stop using the toilet and have the wax ring and flange checked soon. Call (855) 902-0055 to reach a plumber.
Can I replace a faucet or toilet myself?
Many homeowners do. A plumber is helpful when shut-off valves are old or stuck, the toilet flange is damaged, or supply lines and drains need changes. Some areas require permits for certain fixture work.
Why is there low water pressure at only one faucet?
When only one faucet is weak, the cause is usually local: a clogged aerator, debris in the cartridge, a partly closed shut-off valve under the sink, or a kinked supply line. Unscrew and clean the aerator first. If pressure is low at every fixture, the problem is elsewhere in the system, such as a pressure-reducing valve or old pipe. See water line repair.
Should I repair or replace an old toilet?
If the toilet is cracked, constantly needs repairs or is an older high-volume model, replacing it with a newer low-flow toilet can save water. If it is in good shape, simple repairs are usually enough.
Related
Toilet, Sink, Faucet & Shower Repair near you
- Plumber in New York, NY
- Plumber in Los Angeles, CA
- Plumber in Chicago, IL
- Plumber in Brooklyn, NY
- Plumber in Houston, TX
- Plumber in Phoenix, AZ
- Plumber in Philadelphia, PA
- Plumber in San Antonio, TX
- Plumber in Bronx, NY
- Plumber in San Diego, CA
- Plumber in Dallas, TX
- Plumber in San Jose, CA
- Plumber in Austin, TX
- Plumber in Jacksonville, FL
- Plumber in Fort Worth, TX
- Plumber in Columbus, OH
- Plumber in Saint Louis, MO
- Plumber in Charlotte, NC
- Plumber in Indianapolis, IN
- Plumber in San Francisco, CA
- Plumber in Saint Paul, MN
- Plumber in Seattle, WA
- Plumber in Denver, CO
- Plumber in Oklahoma City, OK
Need a plumber?
Drains, leaks, water heaters, sewer lines and emergencies, day or night.
Call (855) 902-0055