Plumbing services
Toilet Repair: Fix a Running, Leaking, Clogged or Wobbly Toilet
Most toilet problems come from a few parts: a worn flapper or fill valve causes running, a failed wax ring or loose bolts cause leaks at the base, and a blockage in the trap or drain causes clogs. These parts are easy to replace. A cracked bowl or tank means replacing the toilet.
A running toilet is more than an annoyance. The EPA WaterSense program notes that toilets are the main source of water use in the home, accounting for nearly 30 percent of indoor water use, and that a leaking toilet can waste about 200 gallons of water per day.
Signs you need toilet repair
- The toilet keeps running or refills on its own
- Water on the floor around the base
- The toilet rocks or wobbles when you sit
- Weak flush or you have to flush twice
- Frequent clogs or slow draining bowl
- Gurgling from the toilet when another fixture drains
- A sewer smell near the toilet
- A crack in the tank or bowl
- The handle sticks or must be jiggled
Why does my toilet keep running?
A toilet that runs constantly or refills by itself every so often is almost always losing water from the tank into the bowl. The usual causes:
- Worn or warped flapper. The rubber flapper at the bottom of the tank stops sealing. This is the most common cause.
- Chain too short or tangled. The flapper cannot close fully.
- Fill valve set too high. Water rises above the overflow tube and drains into the bowl. The water line should sit about an inch below the top of the overflow tube, or at the mark inside the tank.
- Failing fill valve. It does not shut off fully, so it hisses or trickles.
- Cracked overflow tube or worn flush valve seat. These need a flush valve replacement, which usually means removing the tank.
Try the dye test: add a few drops of food coloring to the tank and wait 10 to 15 minutes without flushing. Color in the bowl means the flapper or flush valve is leaking.
Why is water leaking around the base of my toilet?
Water at the base usually comes from one of these:
- Failed wax ring. The seal between the toilet and the floor flange has broken down, often after the toilet has rocked. Water may leak only when you flush. This can soak the subfloor and the ceiling below.
- Loose closet bolts. The toilet moves, which breaks the seal.
- Broken or corroded flange. The ring the toilet bolts to is cracked, rusted or set too low.
- Leaking supply line or shutoff valve. Water runs down the line and pools at the base.
- Tank bolts or tank-to-bowl gasket. Water drips from under the tank.
- Condensation. In humid weather, cold water makes the tank sweat. This is not a leak but can still damage floors.
Wipe everything dry, then check where water appears first after a flush. A plumber can pull the toilet, replace the wax ring or flange and reset it properly.
How do I fix a clogged toilet?
For a simple clog, use a flange plunger (the kind with a soft extension at the bottom) and firm, steady strokes. A closet auger, also called a toilet auger, reaches farther and is safer for the porcelain than a regular drain snake.
Avoid chemical drain cleaners in toilets. They often do not clear the clog and can make the job hazardous for whoever works on it next.
Call a plumber when:
- The toilet clogs often, even with normal use.
- Other drains gurgle or back up when you flush.
- Water comes up in a tub or shower when the toilet is flushed.
- Something solid, like a toy or phone, went down.
Repeated clogs or multiple backed-up fixtures point to a problem in the main drain, not the toilet. See drain cleaning and our guide on sewer backup signs.
Why does my toilet flush weakly?
- Low tank water level from a misadjusted fill valve.
- Flapper closing too early, often from too much chain slack.
- Clogged rim jets and siphon jet from hard water scale. Common in areas with hard water. See our guide on hard water and plumbing.
- Partial clog in the trap or drain.
- Blocked plumbing vent, which can also cause gurgling.
- Older low-flow design. Some early low-flow toilets flush poorly. Newer models are much better.
Should I repair or replace my toilet?
| Situation | Usually |
|---|---|
| Running, weak flush, handle problems | Repair: flapper, fill valve, flush valve or handle |
| Leak at the base | Repair: wax ring, bolts, flange |
| Crack in the tank or bowl | Replace the toilet |
| Constant clogs with a clear drain line | Consider replacing with a better-flushing model |
| Older toilet using much more water than modern models | Consider replacing for water savings |
| Remodel or new accessibility needs | Replace (for example, a comfort-height model) |
Federal standards have limited new toilets to 1.6 gallons per flush since the 1990s. Toilets with the EPA WaterSense label use 1.28 gallons per flush or less while meeting performance testing. A cracked bowl or tank should not be patched, because it can fail suddenly and flood the room.
What does a toilet repair visit include?
- Diagnosis: the plumber checks the tank parts, base, supply line and drain.
- Repair: replacing flappers, fill valves, flush valves, handles, gaskets, bolts, wax rings or flanges as needed.
- Drain clearing with a closet auger or, for deeper clogs, a drain machine or camera inspection.
- Replacement and installation: removing the old toilet, setting the new one on a fresh seal, connecting a new supply line and testing.
- Subfloor check: if the floor is soft around the toilet, the plumber can point out water damage that may need a carpenter.
For sinks, faucets and showers in the same bathroom, see toilet, sink, faucet and shower repair.
Is a broken toilet an emergency?
An overflowing toilet that will not stop, a leak spreading through the ceiling below, or sewage backing up into the home needs fast attention. First, turn the shutoff valve behind the toilet clockwise to stop the water. If that valve is stuck, close the main shutoff. If you have only one toilet and it is out of service, many plumbers treat that as urgent. For around-the-clock help, see emergency plumbing or call (855) 902-0055.
How it works
- Call (855) 902-0055Tell us what is going on and your address. We answer 24/7.
- A local plumber comes outA plumber serving your area arrives, finds the problem and explains it.
- Fixed rightYou get the price before work starts, then the job is done and cleaned up.
Toilet Repair: common questions
How do I stop a toilet from overflowing?
Turn the shutoff valve on the wall behind the toilet clockwise. You can also lift the tank lid and push the flapper down, then lift the float to stop the fill. Do not flush again until the clog is cleared.
Why does my toilet run for a few seconds every so often?
This is called phantom flushing. Water is slowly leaking from the tank to the bowl, and the fill valve tops it off. A new flapper usually fixes it.
Can a leaking toilet damage my floor?
Yes. A failed wax ring can leak a little with every flush, soaking the subfloor and ceiling below for months before you notice. Soft flooring, stains below or a rocking toilet are warning signs.
How long does a toilet last?
The porcelain itself can last for decades. Internal parts such as flappers and fill valves wear out sooner and are routinely replaced. Replace the toilet if it is cracked or keeps failing.
Do I need a plumber to replace a toilet?
Many homeowners replace toilets themselves, but a plumber is the better choice when the flange is damaged, the floor is soft, the drain is clogged beyond the toilet, or the shutoff valve is old and might break.
Related
Toilet Repair near you
- Plumber in New York, NY
- Plumber in Los Angeles, CA
- Plumber in Chicago, IL
- Plumber in Brooklyn, NY
- Plumber in Houston, TX
- Plumber in Phoenix, AZ
- Plumber in Philadelphia, PA
- Plumber in San Antonio, TX
- Plumber in Bronx, NY
- Plumber in San Diego, CA
- Plumber in Dallas, TX
- Plumber in San Jose, CA
- Plumber in Austin, TX
- Plumber in Jacksonville, FL
- Plumber in Fort Worth, TX
- Plumber in Columbus, OH
- Plumber in Saint Louis, MO
- Plumber in Charlotte, NC
- Plumber in Indianapolis, IN
- Plumber in San Francisco, CA
- Plumber in Saint Paul, MN
- Plumber in Seattle, WA
- Plumber in Denver, CO
- Plumber in Oklahoma City, OK
Need a plumber?
Drains, leaks, water heaters, sewer lines and emergencies, day or night.
Call (855) 902-0055